Difference between revisions of "HowTo get aMule web interface"

From AMule Project FAQ
Jump to: navigation, search
(Set aMule web interface)
(Installation of the aMule daemon)
Line 5: Line 5:
 
<center>'''English''' | [[Getting_Started-fr|Français]] | [[Getting_Started-nl|Nederlands]] |
 
<center>'''English''' | [[Getting_Started-fr|Français]] | [[Getting_Started-nl|Nederlands]] |
  
=== Installation of the aMule daemon ===
 
Extract and run
 
$ ./configure --enable-amulecmd --enable-webserver --disable-monolithic --enable-amule-daemon --prefix=/home/''user''/bin/
 
$ make
 
$ make install
 
where the ''--prefix='' parameter is to be replaced with the path of where amule is to be installed.
 
  
If you wish to install the client system-wide, rather that the user's own home directory, the '--prefix=' parameter can be removed.
 
  
 
=== Configuration of the aMule-daemon ===
 
=== Configuration of the aMule-daemon ===

Revision as of 18:58, 19 December 2007

English | Norsk | Deutsch

English | Français | Nederlands |


Configuration of the aMule-daemon

Go to the path where aMule was installed, which in our case is ~/bin and run ./amuled. When this is done, the configuration file ~/.aMule/amule.conf is created.

Quit the daemon again. Find and replace the follwoing lines in ~/.aMule/amule.conf.

  • AcceptExternalConnections=1 <-- To let aMule listen to external connections.
  • ECPassword=56f491c56340a6fa5c158863c6bfb39f <-- MD5 of the password you wish to use.

Use the command md5sum to create a MD5-string of a password:

$ echo -n password | md5sum
56f491c56340a6fa5c158863c6bfb39f -

Configuration of the aMule web interface

The program amuleweb is used to get the web interface running. To create a configuration file for this program, the following parameters are used, where --password is the password used in the amule daemon configuration and --admin-pass is the password to access the web interface itself.

$ ./amuleweb --write-config --host=localhost --password=password --admin-pass=anotherpassword

Then you just have to start amuleweb, and you're done. Be aware that the amule daemon must be running.

$ ./amuleweb

Connecting from your web browser

Go to the web address http://hostname:4711, where hostname is the name of the computer running amuleweb and 4711 is the port amuleweb is using. In most cases this should be http://localhost:4711.

Más informacion