Webserver

From AMule Project FAQ
Revision as of 10:43, 7 February 2005 by 212.242.54.121 (Talk)

Jump to: navigation, search

Setting up Webserver with aMule

Webserver with aMule 1.2.8 or earlier

Webserver with aMule 2.0.0-rc1 or later

  • Untar the sources and copy src/aMule.tmpl and src/webserver/ into your ~/.aMule/ directory. The following (run from the sources directory), should do so:
$ cp -r src/aMule.tmpl src/webserver/ ~/.aMule/
  • If you installed aMule from rpm, then you can do:
$ cp /usr/share/amuleweb/aMule.tmpl ~/.aMule/
$ cp -r /usr/share/amuleweb/webserver/ ~/.aMule/
  • Go to "Preferences"->"Remote Controls" (in aMule) and...
    • Enable "Accept External Connections".
    • Enable "Use TCP ports instead of unix local sockets".
    • Enter a password for external connections. If you don't do this, amuleweb will not communicate with amule.
NOTE: On some early aMule 2.0.0-rcX versions the above options weren't available (or didn't work). If you are using such aMule version and you don't wish to upgrade, then do the following:
Shutdown aMule if it is still running.
Edit your ~/.eMule file, locate the [ExternalConnect] section and change:
AcceptExternalConnections=1 <-- To enable aMule listening for External Connections.
ECUseTCPPort=1 <-- To use the TCP port. Very important since Unix sockets are disabled.
ECPassword=ca3c365274907c6fd527068788e14639 <-- To find the MD5 string for your password, do:
$ echo -n yourpasswordhere | md5sum | cut -d ' ' -f 1
ca3c365274907c6fd527068788e14639
NOTE: When you change your webserver and External Connections ports here, make sure to restart aMule.
NOTE: that "Enable Webserver" has no effect and will be renamed in 2.0.0rc8. Webserver is always enabled as long as you have External Connections enabled.
NOTE: For users running aMule Daemon you have to edit the .eMule file like shown above. For a way to setup a password check the 1.2.8 aMule HowTo. You can still do it in the same way.
  • Now you're done! You are ready to run amuleweb and connect to it.

Stefanero

Connecting to amuleweb

To run aMuleWeb run amuleweb on a terminal. For more information about running aMuleWeb check the aMuleWeb document.

Once aMuleWeb is running, open a web browser and connect to:

http://host:port

where host stands for your host's name (try with localhost) and port stands for the aMuleWeb port (NOT the External Connections port).

For example: http://localhost:4711

Standard ports

The ports can be set to anything, but this are the most used (the standard ones):

Make sure you do not confuse with what each of them is.

Where to report problems and questions?

For Problems or Questions just report on http://forum.amule.org forum or join IRC channel #amule at irc.freenode.net