Difference between revisions of "Firewall"

From AMule Project FAQ
Jump to: navigation, search
Line 1: Line 1:
 +
 +
<center>'''English''' | [[Editing_Firewall-es|Español]] </center>
 +
 +
 
'''NOTE:''' If you run [http://www.suse.com SuSE Linux], try [[Firewall_SuSE|this HowTo]] first.
 
'''NOTE:''' If you run [http://www.suse.com SuSE Linux], try [[Firewall_SuSE|this HowTo]] first.
  

Revision as of 23:46, 19 April 2005

English | Español


NOTE: If you run SuSE Linux, try this HowTo first.

If you set TCP port in aMule to XX and UDP port to YY then you have to set your firewall like this:

iptables -A INPUT -p tcp --dport XX -j ACCEPT
iptables -A INPUT -p udp --dport XX+3 -j ACCEPT
iptables -A INPUT -p udp --dport YY -j ACCEPT

If you are building your iptables-rules from scratch, you also need to allow ESTABLISHED and RELATED traffic to come through your firewall:

iptables -A INPUT -m state --state ESTABLISHED,RELATED -j ACCEPT

And you must enable traffic to leave your machine aswell, by either allowing all outgoing traffic:

iptables -P OUTPUT ACCEPT

or specifying special rules.

NOTE: for Mandrake 10.0 Official and iptables you may have to change the multi-port entry to iptables -A INPUT -p udp --dport XX:ZZ -j ACCEPT where XX is the same TCP port number used in first line and ZZ is that number plus 3 (eg: 4662:4665)

If you want to setup aMule behind a NAT gateway, you should add these lines to your iptables configuration script, on the gateway :

EXTIF is your external interface

EMULEPORT=4662
EMULEUDP=4672
EMULEUDP2=`expr $EMULEPORT + 3`
EMULEHOST=10.0.0.2
iptables -t nat -A PREROUTING -i $EXTIF -p tcp --destination-port $EMULEPORT -j DNAT --to-destination $EMULEHOST:$EMULEPORT
iptables -t nat -A PREROUTING -i $EXTIF -p udp --destination-port $EMULEUDP -j DNAT --to-destination $EMULEHOST:$EMULEUDP
iptables -t nat -A PREROUTING -i $EXTIF -p udp --destination-port $EMULEUDP2 -j DNAT --to-destination $EMULEHOST:$EMULEUDP2


You also should make sure that your FORWARD-string is set up correctly. Usually, you will have an entry like this:

iptables -A FORWARD -i $EXTIF -o $INTIF -d $EMULEHOST -m state --state ESTABLISHED,RELATED -j ACCEPT

where INTIF is your internal interface and EMULEHOST is the host running the eD2k server on your internal network.

This will prevent new connections. So, you should allow all forwarding for aMule-related ports:

iptables -A FORWARD -i $EXTIF -o $INTIF -p tcp --dport $EMULEPORT -d $EMULEHOST -j ACCEPT
iptables -A FORWARD -i $EXTIF -o $INTIF -p udp --dport $EMULEUDP -d $EMULEHOST -j ACCEPT
iptables -A FORWARD -i $EXTIF -o $INTIF -p udp --dport $EMULEUDP2 -d $EMULEHOST -j ACCEPT

Once everything is set, you can check here if your ports are now open.