AMule makes everything slow
From AMule Project FAQ
Revision as of 16:58, 25 September 2008 by Vollstrecker (Talk | contribs)
English | Deutsch | Español | Magyar | Nederlands
aMule makes everything slow
So when you are running aMule, suddenly every other application using the net runs slow. Then you should read this document carefully.
How to fix this problem
Well, the reason is that you have badly configured aMule. Check the following:
- "Preferences"->"Connection"->"Bandwidth Limits"->"Upload": If this value is very high, so high that it takes more than 75% of your upload bandwidth, you will get very bad downloading speeds, since most packets on the internet are TCP packets, which require both up and down packets. In other words, to download something, you need to upload some information.
- "Preferences"->"Connection"->"Max Sources per File"->"Hard Limit": This specifies the maximum amount of sources you allow for each file being downloaded. Each source periodically requires a connection, so more sources require more connections and so, a bit of bandwidth. Have in mind that if you are downloading F files at the same time (where F is a number) and you set Hard Limit's value to X (where X is a number), you may allow up to X*F sources overall.
- "Preferences"->"Connection"->"Connection Limits"->"Max Connections": This specifies the maximum amount of connections you allow aMule to have open at the same time. Once again, each connection takes a bit of your bandwidth so, adjust it to whatever suits you.
- "Preferences"->"Core Tweaks"->"Max new connections / 5 secs": This specifies the maximum number of new connections you allow aMule to open in any 5 second period. Certain routers can't cope with a lot of connections being opened in a short period of time. They may slow down or they may lock up. Reduce this setting if your router exhibits this problem.
- "Preferences"->"Core tweaks"->"Verbose log": On old wxWidgets versions (prior to 2.5.4), verbose log filling the servers log causes high CPU usage. Disable it.
- Files with auto-priority must be set to other than auto if you find hard disk usage is too high.
What are the values that suit my needs
This will depend on your connection type (ISDN, Modem, DSL, Cable, T1, etc...), your ISP, the bandwidth your other apps need and the amount of files you are downloading (also, in the CPU if it is slow).
As you see, it is very personal and it's impossible to tell what suits your needs and what not. The only way to get it right is to go testing. The procedure is:
- Set it to some value.
- If it's ok: then tweak those values a little to see if you can get some more connections (improving the speed) without losing effectiveness on the other apps.
- If the other apps suffer from lack of bandwidth: lower the values so that aMule takes less bandwidth.
- Repeat the above steps until you find the values which suit better your needs.