Difference between revisions of "AMuleCMD"
From AMule Project FAQ
| Line 13: | Line 13: | ||
Quit | Quit | ||
| + | |||
Help | Help | ||
| + | |||
Stats | Stats | ||
| + | |||
Show DL | Show DL | ||
| + | |||
Resume n | Resume n | ||
| + | |||
Pause n | Pause n | ||
| + | |||
ServerStatus | ServerStatus | ||
| + | |||
Connect | Connect | ||
| + | |||
.Disconnect | .Disconnect | ||
You can also do "Show UL" which doesn't do anything as of rc5 version. | You can also do "Show UL" which doesn't do anything as of rc5 version. | ||
Revision as of 04:01, 24 September 2004
To run AMuleCMD simply type the command name at a command prompt. Note it's all lower case.
$>amulecmd
(This is based on linux. You may need to go to the actual directory on other o/s's if it's not in the path.)
I needed to set "use tcp ports instead of unix local sockets" to be on, in Preferences->Remote Connection->External Connection Parameters.
You can also set the password in same preferences section.
With aMule v2.0.0rc5: According to the amulecmd help you can perform the following commands.
Quit
Help
Stats
Show DL
Resume n
Pause n
ServerStatus
Connect
.Disconnect
You can also do "Show UL" which doesn't do anything as of rc5 version.
