AMuleCMD

From AMule Project FAQ
Revision as of 04:00, 24 September 2004 by 203.217.44.171 (Talk)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

To run AMuleCMD simply type the command name at a command prompt. Note it's all lower case.

$>amulecmd

(This is based on linux. You may need to go to the actual directory on other o/s's if it's not in the path.)

I needed to set "use tcp ports instead of unix local sockets" to be on, in Preferences->Remote Connection->External Connection Parameters.

You can also set the password in same preferences section.

With aMule v2.0.0rc5: According to the amulecmd help you can perform the following commands.

Quit Help Stats Show DL Resume n Pause n ServerStatus Connect .Disconnect

You can also do "Show UL" which doesn't do anything as of rc5 version.