Part.met.seeds file

File

Name: *.part.met.seeds

Location: ~/.aMule/Temp/

Description

This file contains up to 5 sources for a file in aMule's download queue. This are known as seed.

Format

The format of this files is as follows:

• Number of sources <- Amount of sources that will be listed (8 bits unsigned integer)
• For each source it has:
  • Source's ID <- The source's ID (4 bytes unsigned integer in little endian)
  • Source's port <- The source's port (2 bytes unsigned integer in little endian)

The whole file is then written in packets of 2 bytes in little endian.

Example

This is the contents of a valid seeds file (after endianess conversion to big endian:

05 41 65 1C 50 2A 2D 6E F3 2D 53 36 12 2F F1 CA
51 36 12 BF EA 7E C8 36 12 C1 31 3C D5 D5 30

Which can be read as:

05 <- 5 sources will be listed (which is the maximum amount of sources aMule allows to list in seeds files)

41 65 1C 50 <- First sources' ID, which, after performing endiannes conversion, becomes 50 1C 65 41 in hex and 1344038209 in decimal. This corresponds to IP 80.28.101.65

2A 2D <- First sources port to communicate is port 15658 (since in big endian hex it would be 2D 2A)

6E F3 2D 53 <- Second source's IP: 83.45.243.110

36 12 <- Second source's port: 4662

2F F1 CA 51 <- Third source's IP: 81.202.241.47

36 12 <- Third source's port: 4662

BF EA 7E C8 <- Fourth source's IP: 200.126.234.191

36 12 <- Fourth source's port: 4662

C1 31 3C D5 <- Fifth source's IP: 213.60.49.193

D5 30 <- Fifth source's port: 12501

Notes

• Since from a LowID you cannot tell it's IP, LowID clients should never make it into seeds files since it would be impossible to locate them later. So, seeds files only contain HighID sources.
• aMule limits the amount of sources that can be listed to 5, but the file format could accept up to 255 sources (since the number of sources is told through an 8 bits unsigned integer).