Difference between revisions of "AMuleCMD"
From AMule Project FAQ
m (links) |
|||
| Line 3: | Line 3: | ||
$>amulecmd | $>amulecmd | ||
| − | (This is based on linux. You may need to go to the actual directory on other | + | (This is based on [[linux.definition|Linux]]. You may need to go to the actual directory on other OS's if it's not in the path.) |
| − | I needed to set "use tcp ports instead of unix local sockets" to be on, in Preferences->Remote Connection->External Connection Parameters. | + | I needed to set "use [http://www.networksorcery.com/enp/protocol/tcp.htm TCP] ports instead of [http://www.unix.org Unix] local sockets" to be on, in Preferences -> Remote Connection -> External Connection Parameters. |
| − | You can also set the password in same | + | You can also set the password in same Preferences section. |
| − | With aMule | + | With [[aMule]] 2.0.0-rc5: |
According to the amulecmd help you can perform the following commands. | According to the amulecmd help you can perform the following commands. | ||
Revision as of 00:25, 28 September 2004
To run AMuleCMD simply type the command name at a command prompt. Note it's all lower case.
$>amulecmd
(This is based on Linux. You may need to go to the actual directory on other OS's if it's not in the path.)
I needed to set "use TCP ports instead of Unix local sockets" to be on, in Preferences -> Remote Connection -> External Connection Parameters.
You can also set the password in same Preferences section.
With aMule 2.0.0-rc5: According to the amulecmd help you can perform the following commands.
Quit
Help
Stats
Show DL
Resume n
Pause n
ServerStatus
Connect
.Disconnect
You can also do "Show UL" which doesn't do anything as of rc5 version.
